![]() ToDo Using DomESP1 board with a unconnected doorbell pushbutton Using DomESP1 board with a doorbell pushbutton already used to ring the door bell In our case, if the doorbell switch wires arrives in another place than Domoticz/Raspberry room, it's possible to use this board without the need to install other wires to the Raspberry location. In the following examples, DomESP1 is a board, develped by us, with some analog/digital inputs, relay/photomos outputs, 1wire and I2C bus, where it's possibile to plug the NodeMCU V3 ESP8266 controller: it supports WiFi connections at 2.4GHz, and can be easily configured by a web browser it's possible to define the parameters of the Domoticz controller so it will update the status of virtual inputs/outputs/sensors on Domoticz through a WiFi connection. ![]() You must connect the doorbell pushbutton wires to a domoticz input switch (see next sections). You must use Raspberry PI board with Domoticz software installed. When people come to your home and press the doorbell switch, immediately a picture is grabbed from the IPCAM at your house and sent to your Telegram app on smartphone or computer. ![]() The purpose of this document is to illustrate how to configure and connect Domoticz/Raspberry controller to get a snapshot on our Telegram app when someone push the doorbell. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |